EasyManua.ls Logo

Remco LP-BK01 - Maintenance Procedures; Lube Pump Regular Operation; Vehicle Transmission Maintenance

Default Icon
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
6. Call REMCO for information.
CONDITIONS:
RV “ON”, with towed vehicle connected
PROBLEM: All monitor lights are OFF (red and green)
1. With the engine switch “ON”, check the fuse in the orange wire at the 1 AMP fuse holder
in the orange wire.
2. Check connection to ignition accessory terminal. See INSTALLATION OF
ELECTRONIC MONITOR, Step 2.
3. Check the white ground connection from the monitor.
4. If the above checks are OK, call REMCO Industries.
MAINTENANCE
1. Lube pumps should be ran every 4 to 6 weeks for 15 to 20 minutes. This will keep your
pump lubricated and extend diaphragm life. If you are not able to run your lube pump
using your motorcoach, asks your REMCO dealer about the Off-Season Run kit (part
number 10010040) not included with the lube pump kit. The Off-Season Run Kit will
allow you to use your vehicles battery to run your lube pump.
2. It is important to following the manufacture’s scheduled maintenance for your vehicle’s
transmission, you will find this information in your owner’s manual.

Related product manuals