8
IMPORTANT!
INSTALL THE LUBE PUMP AND ALL NECESSARY PLUMBING ON
TOWED VEHICLE FIRST BEFORE INSTALLING WIRING ON MOTOR
COACH AND TOWED VEHICLE.
SEE
LUBE PUMP AND PLUMBING INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS COME WITH THE SPECIFIC HARDWARE
PACK FOR YOUR TRANSMISSION. IF YOU DO NOT HAVE THIS
HARDWARE PACK, DO NOT CONTINUE WITH THE
INSTALLATION! CALL REMCO IMMEDIATELY!
TOWED VEHICLE ELECTRICAL WIRING:
The REMCO LUBE PUMP KIT includes all wiring and electrical hardware needed to connect
the electronic monitor on the motor home dash panel and the LUBE PUMP in the towed vehicle.
The kit provides for the automatic control of the taillights and turn signals of the towed vehicle.
NOTE: Some motorhomes have amber turn signals and red brake lights which requires the use
of a tail light converter to change the wiring schematics. A tail light converter is not supplied with
this Taillight Wiring Kit. You can purchase them through your local provider or automotive parts
supplier.
Check the parts in the kit, against the parts list below, to familiarize yourself with each item and
to make sure none are missing.
For proper installation it is necessary for you to have available the following tools which are not
provided in the kit:
12 volt DC continuity tester
Small wire cutter, wire stripper, wire terminal crimper
Electric drill, #7 drill bit, and 3/8 nut driver bit
To Next Page
Loading...
