7
THE REMCO LUBE PUMP
REMCO’s Lube-Pump provides a proven, safe and reliable method of towing select front wheel
drive, rear wheel drive, four wheel drive, and all-wheel drive automatic transmission vehicles
behind your motor home with all four wheels on the ground. REMCO’s Lube Pump Systems
are Transmission dependent. Please make sure your vehicle is equipped with a Transmission that
has been approved by REMCO for use with the Lube Pump. REMCO provides the pump system,
tail light system and all electrical connections. REMCO can provide the tow bar and brackets
for most vehicles.
A durable 1/8 horsepower self-priming pump provides effective lubrication of the towed vehicle’s
transmission while being towed. The pump is activated or deactivated when the electrical monitor
is switched on or off and the motor home’s ignition is in the ON position.
The motor home is connected to the towed vehicle with a single cable, which operates the pump,
monitor, and the towed vehicle’s taillights. When the cable is connected, the taillights, brake
lights, and turn signals of the towed vehicle are automatically controlled from the motor home.
When the cable is disconnected, the taillights, turn signals, and brake lights of the towed vehicle
operate normally.
In addition, a fail-safe electronic alarm system is built into the monitor, giving you a visual and
audible signal if for any reason your LUBE-PUMP is not delivering adequate lubrication. One
more unique feature of the alarm system is when you plug your towed vehicle into your motor
home, with the motor home ignition ON, the red light and alarm will operate until the monitor
switch is turned ON and the pump begins operating so you don’t drive down the road with the
pump off and in the process ruin your transmission.
The REMCO LUBE-PUMP is designed to give you maximum convenience and safety when the
system is properly installed. Please follow the installation instructions very carefully. Any
questions or problems, please call REMCO at 1-800-228-2481.
* * WARNING * *
SAFETY FIRST – Use caution when working on a vehicle. Do not get hands into fan belts or
other moving parts. Do not get under any vehicle that is supported by a jack only. Be sure vehicle
is properly blocked and supported by jack stands before getting under it.
CAUTION – An improperly installed LUBE-PUMP system can cause failure of the towed
vehicle’s transmission and other system components. All motor home electrical power used for
the monitor, pump, or towed vehicle’s taillights must be 12 volts DC. Bus type chassis may have
24-volt DC electrical system and will need to be converted to 12 volts DC. A 12-volt source must
be on the motor home to run the monitor, pump, and converter.
To Next Page
Loading...
