24
INSTALLATION OF CONDUCTOR CABLE FOR 3-WIRE SYSTEMS
NOTE: Refer to DIAGRAM , page 25 for the steps listed below.
Step 1. Route the conductor cable from the socket to the diverters.
Step 2. Separate the towed vehicle’s conductor cable sufficiently to attach to the diverters.
Step 3. Strip each wire ¼”. Crimp a ¼” female terminal onto the yellow, green, and brown
conductor wire.
Step 4. Locate the “TAILLIGHT” diverter. Connect the brown conductor wire to the
remaining “IN” terminal of the diverter.
Step 5. Locate the “LEFT TURN” diverter. Connect the yellow conductor wire
to the remaining “IN” terminal of the diverter.
Step 6. Locate the “RIGHT TURN” diverter. Connect the green conductor wire
to the remaining “IN” terminal of the diverter.
At this point return to pg 15
for the
Motorhome Electrical Instructions
To Next Page
Loading...
