What to do if the REMEHA Quinta Pro 30 flow temperature sensor has an open circuit?
If the flow temperature sensor of your REMEHA Boiler has an open circuit, first check the wiring for any bad connections. Also, check that the sensors are operating correctly and that the sensor has been correctly fitted. If the problem persists, replace the sensor.
How to fix REMEHA Quinta Pro 30 storage unit PSU parameter not found?
If the storage unit PSU parameter is not found in your REMEHA Boiler, the problem could be a bad connection. Check the wiring to resolve this issue.
What to do if there is no flame during operation in my REMEHA Quinta Pro 30?
If there's no flame during operation of your REMEHA Boiler, here's what you can check: * Vent the gas supply to remove any air. * Ensure the gas valve is fully opened and verify the gas supply pressure. * Check the operation and setting of the gas valve unit. * Make sure the air supply inlet and flue gas outlet are not blocked. * Ensure there is no recirculation of flue gases.
Why is the maximum flow temperature exceeded in my REMEHA Quinta Pro 30?
If the maximum flow temperature is exceeded in your REMEHA Boiler, it could be due to no flow or insufficient flow. Check the flow (direction, pump, valves) and reasons for the heat demand.
What to do if the maximum increase of the flow temperature has been exceeded in my REMEHA Quinta Pro 30?
If the maximum increase of the flow temperature has been exceeded in your REMEHA Boiler, it could be due to no flow or insufficient flow. Check the flow (direction, pump, valves). Also, check the water pressure and the cleanliness of the heat exchanger.
Why is the maximum difference between the flow and return temperature exceeded in my REMEHA Quinta Pro 30?
If the maximum difference between the flow and return temperature has been exceeded in your REMEHA Boiler, it may be due to no flow or insufficient flow. You should check the flow (direction, pump, valves). Also, check the water pressure and ensure the heat exchanger is clean.
What causes the gas pressure to be too low in my REMEHA Quinta Pro 30 Boiler?
If the gas pressure is too low in your REMEHA Boiler, check that the gas valve is fully opened and check the gas supply pressure. Also, check whether the GPS has been correctly fitted and replace the GPS switch if necessary.
How to fix a short-circuited flow temperature sensor in my REMEHA Quinta Pro 30?
If the flow temperature sensor is short-circuited in your REMEHA Boiler, check the wiring and ensure the sensor has been fitted properly. Also, check that the sensors are operating correctly and replace the sensor if necessary.
What to do if the temperature of the heat exchanger is too low in my REMEHA Quinta Pro 30?
If the temperature of the heat exchanger is too low in your REMEHA Boiler, check the wiring and ensure the sensors are operating correctly and that the sensor has been fitted properly. Replace the sensor if necessary. Also, vent the air from the CH system, check the circulation (direction, pump, valves), check the water pressure and the cleanliness of the heat exchanger. If present, check the boiler type parameter setting.
How do I troubleshoot a short-circuited return temperature sensor in my REMEHA Boiler?
If the return temperature sensor is short-circuited in your REMEHA Boiler, check the wiring. Also, check that the sensors are operating correctly and replace the sensor if necessary.
General| Model | Quinta Pro 30 |
|---|---|
| Category | Boiler |
| Type | Condensing Boiler |
| Output | 30 kW |
| Fuel | Gas |
| Warranty | 2 years |
| Fuel Type | Natural Gas |
| Efficiency | 98% (GCV) |
To Next Page
