How do I troubleshoot a short-circuited return temperature sensor in my REMEHA Boiler?
If the return temperature sensor is short-circuited in your REMEHA Boiler, check the wiring. Also, check that the sensors are operating correctly and replace the sensor if necessary.
How to fix REMEHA Quinta Pro 45 Boiler maximum flow temperature exceeded?
If the maximum flow temperature is exceeded in your REMEHA boiler, it could be due to no flow or insufficient flow. Check the flow (direction, pump, valves) and reasons for the heat demand.
What to do if the water pressure is too low in my REMEHA Quinta Pro 45 Boiler?
If the water pressure is too low in your REMEHA Boiler, you should check the water pressure. Also, fill the boiler and the installation with water.
How to fix return temperature sensor short circuit in REMEHA Quinta Pro 45?
If the return temperature sensor is short circuited in your REMEHA Boiler, check the wiring for bad connections. Also, check that the sensors are operating correctly and that the sensor has been correctly fitted.
What causes a fan operation error in a REMEHA Boiler?
If there is a fan operation error in your REMEHA Boiler, check the wiring. Also, if the fan is defective, check for adequate draw on the chimney connection and replace the fan if necessary.
Why REMEHA Quinta Pro 45 Boiler heat exchanger temperature is too high?
If the temperature of heat exchanger is too high in your REMEHA Boiler, check the wiring for bad connections. Also, check that the sensors are operating correctly and that the sensor has been correctly fitted. If there is no circulation, check the circulation (direction, pump, valves). You may also need to check the water pressure and the cleanliness of the heating body.
How to fix REMEHA Quinta Pro 45 Boiler storage unit PSU parameter not found?
If the storage unit PSU parameter is not found in your REMEHA Boiler, the problem could be a bad connection. Check the wiring to resolve this issue.
What to do if there is no flame during operation in my REMEHA Quinta Pro 45?
If there's no flame during operation of your REMEHA Boiler, here's what you can check: * Vent the gas supply to remove any air. * Ensure the gas valve is fully opened and verify the gas supply pressure. * Check the operation and setting of the gas valve unit. * Make sure the air supply inlet and flue gas outlet are not blocked. * Ensure there is no recirculation of flue gases.
What to do if REMEHA Boiler shows communication error with the SCU PCB?
If your REMEHA boiler shows a communication error with the SCU PCB, it may be due to a poor connection with the BUS or the SCU PCB not being present in the boiler. Check the wiring and carry out automatic detection.
What causes REMEHA Boiler fan operation error?
A fan operation error in your REMEHA boiler could stem from a bad connection or a defective fan. Ensure adequate draw on the chimney connection and replace the fan if necessary.
To Next Page
General