ENGINE AND PERIPHERALS
Overhauling the engine
10
10-78
Fitting the crankshaft bearing shells
Identification
Only grooved and pierced crankshaft bearing shells
are supplied as spares, whatever the crankshaft
lubrication configuration.
Fit the shells on to the bearings and the cylinder block
and oil them.
Fit the side shims for crankshaft n˚ 2 (grooves on the
crankshaft side).
Grease the crankpins and bushings with engine oil.
Refit:
– the crankshaft,
– the crankshaft bearing caps except caps 1 and 5.
Tightening torque: 8.75 to 9.75 daNm
16529S
16530S
ProCarManuals.com
To Next Page
Loading...
