ENGINE AND PERIPHERALS
Overhauling the engine
10
10-82
Lightly coat the inner surfaces of the cylinder block in
(B) with RHODORSEAL 5661 without obstructing the
oil grooves.
Fit the caps and tighten them to a torque of 8.75 to
9.75 daNm.
Mix 45 ml of RHODORSEAL 5661 (approximately half
a 100 g tube) with half the tube of hardener. Stir with
the spatula until the mixture forms a smooth, light pink
paste.
Insert the mixture into the syringe and inject it into the
grooves of the crankshaft bearing cap.
Let the paste run out slightly on either side of the
grooves of the crankshaft bearing cap, to ensure that it
has completely filled the sealing groove.
89194R
89195S
89196S
ProCarManuals.com
To Next Page
Loading...
