Renault CAPTUR - Page 118

screen wash/wipe
replacing blades ...................................
(current page)
1.104
ENG_UD79846_2
Essuie-vitre / lave-vitre avant (HJB - Renault)
Before any action involving
the windscreen (washing
the vehicle, de-icing,
cleaning the windscreen,
etc.) return stalk 1 to position B
(stop).
Risk of injury and/or damage.
In the event of obstacles on the
windscreen (dirt, snow, ice etc.),
clean the windscreen (including the
central area located behind the inte-
rior rear view mirror) before starting
the wipers (risk of motor overheat-
ing).
If an object is preventing a blade
from moving, it may stop function-
ing.
Remove the obstacle and reactivate
the wiper using the wiper stalk.
Specific front wiper position
(service position)
This position enables the blades to be
lifted to remove them from the winds-
creen.
It may be useful to:
– to clean the blades;
– to release the blades from the wind-
screen in winter;
– replace the blades ➥ 5.34.
With the ignition on or engine started,
lift the stalk twice 1 to position A (single
sweep).
The blades stop slightly away from the
bonnet.
To return the blades to low position,
with the ignition on, ensure that the
wipers have folded down onto the wind-
screen, then move the stalk 1 to posi-
tion A (single sweep).
Before switching on the ignition,
place the wipers on the windscreen.
Otherwise, there may a risk of damage
to the bonnet or the wipers when they
are switched on.
G
1
A
B
C
D
E
WINDSCREEN WASH, WIPE (4/5)