Renault CAPTUR - Stop and Start Function

starting the engine .....................................
(up to the end of the DU)
Stop & Start function..................................
(up to the end of the DU)
indicators:
instrument panel ..................................
(up to the end of the DU)
instrument panel messages.......................
(up to the end of the DU)
engine standby ..........................................
(up to the end of the DU)
instrument panel ........................................
(up to the end of the DU)
2.12
ENG_UD82506_6
Fonction Stop and Start (HJB - Renault)
The vehicle equipment remain opera-
tional while the engine is stopped.
When the engine switches to standby,
the steering assistance may no longer
be operational.
In this case it becomes operational
again when the engine is no longer on
standby or the speed exceeds approxi-
mately 1 mph (1 km/h) (downhill, slope
etc.).
stop and start function
STOP AND START FUNCTION (1/4)
The engine MUST be
stopped (not put in standby)
before leaving the vehicle.
➥ 2.4 ➥ 2.6.
If the engine is put in
standby, the electronic
parking brake (depending
on the vehicle) is not ap-
plied automatically.
This system enables a reduced fuel
consumption and lower greenhouse
gas emissions. The system is acti-
vated automatically when the vehicle
is started. During driving, the system
stops the engine (standby) when the
vehicle comes to a stop or is moving
at a slow speed (depending on the ve-
hicle). The
 warning light is dis-
played on the instrument panel.
Conditions of standby at low
speed
The vehicle has set off from where it
was parked;
For vehicles equipped with auto-
matic gearboxes:
– the gearbox is in position D, M or N;
and
– the brake pedal is depressed (suffi-
ciently hard);
If the
 warning light flashes,
this means that the brake pedal is
not sufficiently pressed;
and
– the accelerator pedal is not de-
pressed;
and
– the speed is zero or, depending on
the vehicle, as soon as the speed is
lower than a threshold specific to the
vehicle.
The engine remains on standby if posi-
tion P is selected, or if position N is se-
lected with the handbrake engaged and
the brake pedal released.
For vehicles equipped with manual
gearboxes:
– the gearbox is in neutral;
and
– the clutch pedal is released. If the
 warning light flashes, this
means that the clutch pedal must be
released completely;
and
– the vehicle speed is lower than a
threshold specific to the vehicle.
For all vehicles:
Warning light
 on the instru-
ment panel is lit when the engine is on
standby.
Keep your vehicle station-
ary when the engine is
on standby (shown by the
warning light
 on the
instrument panel).