Renault CAPTUR - AUTOHOLD Function

Autohold ....................................................
(up to the end of the DU)
driving ........................................................
(up to the end of the DU)
Stop & Start function..................................
(current page)
brake..........................................................
(up to the end of the DU)
parking brake .............................................
(current page)
electronic parking brake ............................
(up to the end of the DU)
indicators:
instrument panel ..................................
(current page)
Stop & Start ...............................................
(current page)
instrument panel ........................................
(current page)
2.29
ENG_UD71749_3
Autohold (HJB - Renault)
Conditions for interrupting the
braking force
The following conditions must be met:
– the driver accelerates sufficiently
with a gear engaged;
or
– the driver disables the function.
Warning light
 goes out on the in-
strument panel.
“AUTOHOLD” function
“AUTOHOLD” FUNCTION
Vehicle stopped (e.g. at a red light, an
intersection, a traffic jam, etc.), the func-
tion ensures braking force even when
the driver releases the brake pedal.
The braking force is released as soon
as the driver accelerates sufficiently
with a gear engaged.
Activation
Press switch 2.
The 1 switch warning light 2 illuminates
to confirm that the function is activated.
Deactivation
Press the brake pedal and 2 switch si-
multaneously.
The 1 switch warning light 2 disappears
to confirm that the function is deacti-
vated.
If the braking force is maintained, the
parking brake is applied automatically
when:
– the driver exits the vehicle;
or
– the vehicle is immobilised for more
than approximately three minutes.
1
Conditions for maintaining the
braking force
The following conditions must be met:
– the seat belt for the driver is fas-
tened;
and
– the electronic parking brake is re-
leased;
and
– the vehicle is not stationary on a very
steep slope.
The maintained braking force is con-
firmed by the
 warning light on
the instrument panel.
Upon each start-up, the function
continues the mode set at the time
the engine was last switched off.
The electronic parking
brake can be used to im-
mobilise the vehicle. Before
leaving the vehicle, check
that the electronic parking brake is
fully applied.
The indicator light on switch 2 and
the warning light
} on the in-
strument panel illuminate to show
that the parking brake is applied
and switch off when the doors are
locked. Depending on the vehicle, a
sticker is located on the upper sec-
tion of the windscreen to remind you
of this.
2