tyre inflation kit...........................................
(current page)
2.43
ENG_UD74936_5
Avertisseur de perte de pression des pneumatiques (HJB - Renault)
TYRE PRESSURE LOSS WARNING (4/6)
Steps Messages Readings
– Tyre pressure init. at stop The message is displayed during driving. If you want to reset the pressure of the
four tyres, stop the vehicle.
1 Tyre pressure init. long press To reset the pressure of all four tyres, with the vehicle stopped, press and hold
the 5 OK switch to launch resetting until the “If pressure OK [hold on]” message
is displayed.
2 If pressure OK [hold on] The message flashes to indicate that the system has registered the resetting
procedure. If all four tyres have been correctly adjusted to match the tyre pres-
sure values recommended on the tyre pressure label ➥ 4.11, press and hold
switch 5 OK until the message “Operation completed” appears.
3 Operation completed The resetting procedure has been completed successfully. You can now drive.
The table below shows the possible messages related to the tyre resetting procedure.
To Next Page
Loading...
