Renault KlGER - Windscreen Wipers and Washers

1.61
WINDSCREEN WASHING / WIPING (1/2)
In frosty weather, make sure that
the wiper blades are not stuck by ice
(risk of motor overheating).
Keep an eye on the condition of the
blades. They should be replaced as
soon as they become less efficient.
This will occur approximately once
a year. Clean your windscreen reg-
ularly.
If you switch off the ignition before
switching off the windscreen wiper
(position A) the blades will stop at
random on the windscreen.
After switching the ignition back on,
simply move stalk 1 to position B to
place them in the park position.
When working in the engine
compartment, ensure
that the windscreen wiper
stalk 1 is in the B position
(park). Risk of injury.
Before any action on the
windscreen (washing the
vehicle, de-icing, cleaning
the windscreen, etc.), return
stalk 1 to position B (park).
Risk of injury and/or damage.
s
Windscreen Wiper
With the ignition on, pull the
stalk 1 towards you.
A brief pull will trigger a single sweep
of the wipers, in addition to the wind-
screen washer.
A longer pull will trigger three sweeps
of the wipers, in addition to the wind-
screen washer.
n
WindscreenWiper
With the ignition on, move the
stalk 1 around the steering wheel (de-
pending on the version):
A One time Mist removal function.
B Park;
C Intermittent wiping (depends on vehi-
cle version) - The wiper will pause for
several seconds between sweeps.
D Normal wiping speed.
E Fast wiping speed.
1
A
B
C
D
E