1.14
FRONT HEADRESTS
To raise the headrest
Pull the headrest upwards to the de-
sired height.
To lower the headrest
Raise the headrest slightly, then press
tab 2 and lower it to the required height.
To adjust the angle of the
headrest
Depending on the vehicle, tilt section A
towards or away from you to the re-
quired position.
2
A
The headrest is an impor-
tant safety component:
ensure that it is in place and
in the correct position. The
distance between your head and the
headrest and the distance between
the head and section A should be
as small as possible.
1
3
To remove the headrest
Lift the headrest to its highest position.
Press button 1 and lift the headrest to
release it (tilt the seatback backwards
if necessary).
Note: when the headrest is removed,
take care not to change the positions
of rods 3.
To refit the headrest
Pull out the headrest rods 3 as far as-
possible by pulling from the top. Take
care to ensure they are clean and cor-
rectly aligned and, if there are any prob-
lems, check that the notches are facing
forwards.
Insert the headrest rods into the holes
(tilt the seatback backwards if neces-
sary).
Lower the headrest until it locks, press
button 1 and lower the headrest as far
as possible.
Check that each headrest rod 3 is se-
curely locked in the seatback by trying
to pull them up or push them down.
To Next Page
