2.10
– with the engine switched off (eg.
when the engine stalls): when a front
door is opened.
In this case, pull and release switch 3 to
apply the assisted parking brake.
Automatic releasing of the assisted
parking brake
The brake will be released as soon as
the vehicle starts and accelerates.
Before leaving the vehi-
cle, check that the assisted
parking brake is fully ap-
plied. Indicator light 2 on the
switch 3 and indicator light
}
on the instrument panel lights up to
show that the parking brake is ap-
plied but go out when the doors are
locked.
Automatic operation
The assisted parking brake can be
used to immobilise the vehicle when
the engine is stopped by pressing
button 1.
In all other instances, e.g. engine stall-
ing, the assisted parking brake is not
applied automatically. Manual mode
must be used.
For certain country-specific model ver-
sions, the automatic brake application
function is not activated. Refer to the in-
formation on “Manual operation”.
ASSISTED PARKING BRAKE (1/4)
1
2
3
To confirm that the assisted parking
brake is applied, the message “Parking
brake on” and the indicator light }
on the instrument panel and indicator
light 2 on the switch light up.
After the engine is switched off, indi-
cator light 2 goes out several minutes
after the assisted parking brake has
been applied and indicator light
}
goes out when the vehicle is locked.
Note: the message “Apply parking
brake” is displayed on the instrument
panel, accompanied by a beep, to warn
you that the assisted parking brake is
released:
– with the engine running: when the
driver’s door is opened;
To Next Page
