Renault Latitude - Adjusting the Lumbar Support

1.19
DRIVER’S SEAT WITH MASSAGE FUNCTION
Adjusting the lumbar support
on the driver’s seat
You can increase or reduce the sup-
port by pressing the (+) or (-) button
on switch 3/4/5 for the top, middle and
bottom of the lumbar support respec-
tively.
Driver’s seat with massage
function
When the engine is running, you may
use the massage function. If you start
the system, the air pressure drops com-
pletely and the massage function starts
running one minute later. The massage
cycle is approximately 10 minutes and
the break time is 10 seconds between
two cycles.
Note: Three massage cycles in a row
are followed by a 15 minute break to
prevent the system from overheating.
Operation
The air tubes in the seatback will oper-
ate according to each mode by turning
control 6 to the desired mode:
: Mode 2
Operating in order from bottom air tube.
: Mode 1
Operating softly in order from bottom
air tube.
: Random Mode 1
Operating softly at random.
: Random Mode 2
Operating at random.
Note: if you change mode, the new
mode selected replaces the current
mode.
Stopping the function
– Turn control 6 to the OFF position.
– When you restart the system after
having stopped it, the air pressure
drops completely before the mas-
sage function can start running.
– With the massage function
stopped, if you wish to use the
lumbar support device wait until
the air pressure has dropped
completely.
– Stop the engine.
Note: If the massage function is run-
ning, you cannot use the support device
at the same time.
3
4
5
6
For safety reasons, avoid
making any adjustments
when driving. The driver
must always be alert to
sudden events which may occur
when driving.
– Take care not to damage the
seatback with sharp objects. The
air tubes incorporated in the seat-
back may also be damaged.
– In the event of prolonged use of
the massage function, you may
start to feel uncomfortable.