2.13
ASSISTED PARKING BRAKE (4/4)
– If there is a fault, the © warning
light on the instrument panel comes
on accompanied by the message
“Check parking brake”.
Contact your approved Dealer as soon
as possible.
– If there is a fault with the connec-
tion between the braking system and
the instrument panel, the message
“Stop vehicle” is displayed on the in-
strument panel accompanied by the
® warning light and a beep.
Stop as soon as traffic conditions allow
and consult an approved Dealer.
Operating faults
– If the parking brake status is not dis-
played on the instrument panel, the
message “Stop vehicle” appears ac-
companied by a beep.
Apply the parking brake manually by
pulling switch 3 before leaving the ve-
hicle. If the problem recurs, consult an
approved Dealer.
It is therefore essential to
immobilise the vehicle by
engaging first gear (manual
gearbox) or position P (au-
tomatic gearbox). If the slope re-
quires it, chock the vehicle.
If no lights or sounds are
apparent, this indicates
a fault in the instrument
panel. This indicates that it
is essential to stop immediately
(as soon as traffic conditions
allow). Ensure that the vehicle is
correctly immobilised and contact
an approved Dealer.
3
– If there is a serious fault, the mes-
sage “Parking brake fault” is dis-
played on the instrument panel
accompanied by the
© and
® warning lights and a beep.
In this case, stop as soon as traffic con-
ditions allow and consult an approved
Dealer.
To Next Page
Loading...
