2.6
ENG_UD59993_2
Fonction stop and start (X62 - Renault)
STOP AND START FUNCTION (3/3)
– the vehicle speed is above 7 km/h
(downhill slope, etc.);
– repeated pressing on the brake
pedal or braking system require-
ment;
– ...
Special note: depending on the vehi-
cle, for some of these conditions the
automatic restarting of the engine is in-
hibited if a door is open.
Deactivating, activating the
function
Press 1 to deactivate the function.
The 2 switch warning light illuminates.
Pressing again will reactivate the
system. The indicator light 2 in switch 1
goes out.
The system is automatically reactivated
each time the vehicle is started using
the start button ➥ 2.3 .
Operating faults
If warning light 2 lights up without press-
ing switch 1, the system is deactivated.
Please consult an authorised dealer.
The engine MUST be
stopped (not put in standby)
before leaving the vehicle.
➥ 2.3 .
– automatic particle filter cleaning is
underway;
– the “Fast Idle Speed” function is acti-
vated ➥ 2.57 ;
– ...
Warning light
is displayed on the
instrument panel. This notifies you that
the engine is on standby.
Special feature of the automatic
engine re-start
Under certain conditions, the engine
can restart on its own in order to guar-
antee your safety and comfort.
This can occur especially when:
– the outdoor temperature is too low or
too high;
– the “Clear view” function is activated
➥ 3.7 ;
– the battery is not sufficiently charged;
1
2
Deactivate the Stop and
Start function for any opera-
tion performed in the engine
compartment.
To Next Page
Loading...
