Renault Master - Exterior Lighting and Signals; Daytime Running Lights

external lights and signals .................... (up to the end of the DU)
signals and lights ..................................(up to the end of the DU)
lights:
side lights .........................................................(current page)
lights:
dipped beam headlights ................................... (current page)
1.110
ENG_UD60007_2
Eclairages et signalisations extérieures (X62 - Renault)
Jaune Noir Noir texte
k
Dipped beam
headlights
Manual operation
Turn ring 3 until the symbol is opposite
mark 2. This indicator light on the in-
strument panel comes on.
Automatic operation
(depending on vehicle)
Turn ring 3 until the AUTO symbol is op-
posite mark 2: with the engine running,
the dipped beam headlights switch on
or off automatically depending on the
brightness of the light outside, without
any action on stalk 1.
Exterior lighting and signals
EXTERIOR LIGHTING AND SIGNALS (1/5)
š
Side lights
Turn ring 3 until the symbol is opposite
mark 2.
This indicator light on the instrument
panel comes on.
Side position lights
(depending on the vehicle)
These draw other road users’ attention
to the width of the vehicle.
They come on when the side lights are
switched on.
Before driving at night,
check that the electrical
equipment is operating cor-
rectly and adjust the head-
light beams (if your vehicle is not
carrying its normal load). ➥ 1.115.
As a general precaution, check that
the lights are not obscured (by dirt,
mud, snow or objects being trans-
ported).
1
2
3
1
Daytime running lights
function
The daytime running lights come on
automatically with no action on stalk 1
when the engine is started, and they go
off once the engine is switched off.