blind spot warning signal ...................... (up to the end of the DU)
blind spot: warning signal ..................... (up to the end of the DU)
driving aids ...........................................(up to the end of the DU)
driver assistance...................................(up to the end of the DU)
2.36
ENG_UD60008_2
Avertisseur d’angle mort (X62 - Renault)
Blind spot warning
BLIND SPOT WARNING (1/6)
Using information from the sensors 1
installed on each side of the rear
bumper, the system notifies the driver
when another vehicle appears in detec-
tion zone A.
The system is activated when the ve-
hicle’s speed is between approximately
19 mph (30 km/h) and 87 mph
(140 km/h).
1
A
Special feature
Make sure that the 1 sensors are not
obscured (by dirt, mud, snow, etc.).
If a sensor is obscured, the message
“Blind spot clean sensor” will appear on
the instrument panel. Clean the sen-
sors.
A
This function is an addi-
tional driving aid.
This function is not under
any circumstances in-
tended to replace the due care and
attention of the driver, who should at
all times be in control of the vehicle.
1