5.14
ENG_UD57061_1
changement de roue : cric hydraulique (X62 - Renault)
Start pumping using the three exten-
sion pieces 4 placed end to end, avail-
able in the tool kit ➥ 5.4.
Free the wheel from the ground.
Note: the use of the three extension
pieces 4 prevents you having to go
under the vehicle to operate the jack 3
when raising the vehicle.
Remove the screws, then remove the
wheel (take off the central wheel trim if
necessary).
Take the jack 3 out of the tool kit.
Familiarise yourself with the jack ar-
rangement prior to using it.
Using the jack
Position the head of the jack on the
contact points 2 close to the wheel con-
cerned.
Place the jack 3 horizontally. The jack
head must line up with the point 2 pro-
vided.
3
CHANGING A WHEEL: hydraulic jack (2/3)
2
4
To prevent any risk of injury
or damage to the vehi-
cle, raise the jack until the
wheel you are replacing is
a maximum of 3 centimetres off the
ground.
Fit the emergency spare wheel on the
central hub and, depending on the ve-
hicle, turn it to align the mounting holes
in the wheel and the hub.
If bolts are supplied with the emergency
spare wheel, only use these bolts for
the emergency spare wheel.
To Next Page
Loading...
