gear lever..............................................(up to the end of the DU)
sequential gearbox ............................... (up to the end of the DU)
automatic gearbox selector lever..........(up to the end of the DU)
2.59
ENG_UD60260_2
Boite de vitesses Quickshift (X62 - Renault)
SEQUENTIAL gearbox
SEQUENTIAL GEARBOX (1/5)
Selector lever 1
– This allows you to shift directly from
first gear to reverse gear, to select
reverse gear and neutral and to
change gear in manual mode.
– It also allows you to switch between
manual and automatic modes at
any time, with the engine switched
on and reverse gear engaged, by
moving the lever to the left.
Note: the selector lever automatically
returns to the centre position after each
use.
Display
2 Gear display
The gear engaged in manual mode
(M1, M2, M6), neutral gear (N), or
the reverse gear (R) is shown on
the instrument panel display. In au-
tomatic mode, (D) is displayed fol-
lowed by the gear selected (D1, D2,
D6).
3 Load mode
4 Brake pedal depressed warning light
Operation
Switch on the ignition.
The display on the instrument panel
switches on.
If neutral (N) is displayed and is ac-
companied (depending on the vehicle),
by the 4 warning light; press the brake
pedal and start the engine but do not
accelerate.
If a gear other than neutral is engaged,
N flashes on the display accompanied
by the 4 warning light; press the brake
pedal and place the lever in position N.
Start the engine.
Note: do not attempt to start the engine
by pushing the vehicle if the battery is
flat (the display remains off when the ig-
nition is switched on).
1
2
4
3
To Next Page
Loading...
