2.48
ENG_UD59995_2
régulateur-limiteur de vitesse : fonction régulateur (X62 - Renault)
Switching off the function
The cruise control function is deacti-
vated when you press the 5 switch. In
this case, the speed is no longer stored.
The
and indicator lights on the
instrument panel go out, confirming that
the function is deactivated.
Recalling the cruising speed
If a speed is memorised, it can be re-
called, once you are sure that the road
conditions are suitable (traffic, road sur-
face, weather conditions, etc.).
Press the 4 switch (R) if the vehicle
speed is over 18 mph (30 km/h).
Note: if the speed previously stored is
much higher than the current speed,
the vehicle will accelerate more rapidly
to reach this threshold.
When the cruise control is set to
standby, pressing switch 1 (+) re-
activates the cruise control func-
tion without taking into account
the stored speed: it is the speed at
which the vehicle is moving that is
taken into account.
Putting the cruise control
on standby or switching it
off does not cause a rapid
reduction in speed: you
must brake by depressing the brake
pedal.
CRUISE CONTROL (4/4)
1
5
2
Putting the function on
standby
The function is set to standby if you:
– press button 3 (O);
– the brake pedal;
– the clutch pedal or shift into neutral
if the vehicle has a sequential gear-
box.
In all three cases, the cruising speed
remains stored and the message
“Memorised” appears on the instrument
panel.
Standby is confirmed when the green
indicator light goes out.
4
3
To Next Page
