2.63
ENG_UD60260_2
Boite de vitesses Quickshift (X62 - Renault)
SEQUENTIAL GEARBOX (5/5)
The vehicle should always be towed
with the ignition switched off.
Load position
When the vehicle is driven loaded,
press the 5 switch on the dashboard.
The indicator light
§ on the instru-
ment panel will light up.
Load mode is deselected every time
the engine is switched off. It will be nec-
essary to select it again.
Load mode may be used to equal effect
in both automatic and manual modes.
Bleep
– If you hold the vehicle on a slope
for too long without applying the
brakes or handbrake, you will strain
the system (risk of overheating the
clutch).
In this case, an intermittent beep-
ing sound will remind you that you
should put your foot on the brake
pedal or apply the handbrake.
– Never leave the vehicle with the
engine running when in gear. For
safety reasons you will hear an in-
termittent beeping sound when you
open the door if you have not shifted
into neutral or you have not switched
off the ignition or depressed the
brake pedal.
Special circumstances
On a slippery surface or surface with
little grip, change to manual mode
(D/M) and select second gear before
accelerating to avoid wheelspin.
In very cold weather, to ensure opti-
mal passage through the gears, wait a
few seconds before moving the selec-
tor lever out of position N and into posi-
tion Dor R.
Operating faults
i
If this warning light comes on
when the vehicle is being driven,
it indicates a fault in the system. In most
cases, you may still drive the vehicle,
although it will not function perfectly.
Contact an approved dealer as soon as
possible.
Towing a vehicle with a sequential
gearbox
If the gearbox is stuck in a gear:
– switch on the ignition;
– Select neutral with the brake pedal
depressed;
– check that the gearbox is in neutral
(by pushing the vehicle for example).
If you cannot find neutral you must tow
the vehicle with the front wheels raised.
5
To Next Page
Loading...
