1.99
ENG_UD60353_1
Rétroviseurs (BFB - KFB - Renault)
Position memory
– Adjust the door mirrors (see previous
paragraphs);
– Refer to the multimedia instructions
to access the settings memory. Save
the settings.
The positions of the door mirrors in
forward and reverse gear, and the po-
sition of the driver’s seat are saved si-
multaneously.
Rear view mirrors which tilt
in reverse gear
For vehicles equipped with the driver’s
seat with position memory, you can
enter a specific setting for the door mir-
rors when reversing and store the po-
sition.
With the vehicle at a standstill and re-
verse gear engaged, select the door
mirror using switch 2 then, with button 1,
adjust it to the required position.
Recalling the memorised
position
Refer to the multimedia manual to
access recall of the saved position.
Select “ Call back”.
The positions of the door mirrors in
forward gear, reverse and of the front
seats are recalled.
Returning to the driving position
Moving from reverse gear to a forward
gear is done:
– approximately 9 seconds after re-
verse gear has been disengaged
when the speed is lower than 6 mph
(10 km/h);
– forward gear engaged when the
speed is greater than 6 mph
(10 km/h);
– when the engine is stopped;
– when switch 2 is in neutral position.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
1
2
REAR-VIEW MIRRORS (2/3)
To Next Page
