EasyManua.ls Logo

Renault MEGANE - Conditions for Interrupting the Braking Force; Conditions for Maintaining the Braking Force; “Autohold Function

Renault MEGANE
430 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
driving ........................................................
(up to the end of the DU)
electronic parking brake ............................
(up to the end of the DU)
brake..........................................................
(up to the end of the DU)
instrument panel ........................................
(current page)
indicators:
instrument panel ..................................
(current page)
parking brake .............................................
(current page)
Autohold ....................................................
(up to the end of the DU)
2.21
ENG_UD63803_2
Autohold (BFB - KFB - Renault)
Conditions for interrupting the
braking force
The following conditions must be met:
– the driver accelerates sufficiently
with a gear engaged;
or
– the driver disables the function.
Warning light
goes out on the in-
strument panel.
“AUTOHOLD” function
“AUTOHOLD" FUNCTION
Vehicle stopped (e.g. at a red light, an
intersection, a traffic jam, etc.), the func-
tion ensures braking force even when
the driver releases the brake pedal.
The braking force is released as soon
as the driver accelerates sufficiently
with a gear engaged.
Activation
Press the switch 3.
The switch warning light 3 illuminates
to confirm that the function is activated.
Deactivation
Press the brake pedal and 3 switch si-
multaneously.
The switch warning light 3 turns off,
confirming that the function is deacti-
vated.
If the braking force is maintained, the
parking brake is applied automatically
when:
– the driver exits the vehicle;
or
– the vehicle is immobilised for more
than approximately three minutes.
Before leaving the vehicle,
check that the electronic
parking brake is fully ap-
plied. Warning light 1 on
switch 2 and warning light
} on
the instrument panel illuminate to
show that the parking brake is ap-
plied but switch off when the doors
are locked.
3
1
Conditions for maintaining the
braking force
The following conditions must be met:
– the seat belt for the driver is fas-
tened;
and
– the electronic parking brake is re-
leased;
and
– the vehicle is not stationary on a very
steep slope.
The maintained braking force is con-
firmed by the
warning light on
the instrument panel.
Upon each start-up, the function
continues the mode set at the time
the engine was last switched off.
2

Table of Contents