2.9
ENG_UD63274_2
Fonction Stop and Start (BFB - KFB - Renault)
Conditions for coming out of
engine standby
For vehicles equipped with auto-
matic gearboxes:
– when the driver’s door is opened;
or
– when the driver’s seat belt is unfas-
tened;
or
– the brake pedal is released and posi-
tion D or M engaged (depending on
the vehicle);
or
– the brake pedal is released in gear
position N with the handbrake off;
or
– the brake pedal is pressed again in
gear position P or N engaged with
the handbrake applied;
or
– the vehicle is in gear position R;
or
– the accelerator pedal is depressed;
or
– depending on the vehicle, in manual
mode (M), the gear change paddles
are activated ➥ 2.123.
FUNCTION STOP AND START (2/4)
Preventing the engine from
standing by
In certain situations, such as negotiat-
ing a crossroads for instance, it is pos-
sible (with the system activated) to keep
the engine running so as to be ready to
move off quickly.
For vehicles equipped with au-
tomatic gearboxes and when the
engine standby is performed only
when the vehicle stopped:
Keep the vehicle stationary without
pressing too hard on the brake pedal.
For vehicles equipped with manual
gearboxes:
Keep the clutch pedal pressed right
down.
“AUTOHOLD" function activated
➥ 2.21, the brake pedal may be
released and the engine standby
maintained.
Press the accelerator pedal to exit
vehicle standby.
To fill up with fuel, the engine must
be stopped (and not put in standby):
you MUST stop the engine ➥ 2.4
➥ 2.5.