engine oil ...................................................
(up to the end of the DU)
engine oil level ...........................................
(up to the end of the DU)
maintenance:
mechanical ...........................................
(up to the end of the DU)
filter
oil filter .................................................
(up to the end of the DU)
engine oil capacity .....................................
(up to the end of the DU)
oil change ..................................................
(up to the end of the DU)
levels:
engine oil .............................................
(up to the end of the DU)
engine oil grade .........................................
(up to the end of the DU)
4.5
ENG_UD60418_1
Niveau huile moteur : appoint, remplissage (BFB - KFB - Renault)
Engine oil level: topping up and filling
ENGINE OIL LEVEL: topping up, filling, draining (1/3)
Topping up/Filling
The vehicle must be parked on level
ground and the engine should be cold
(for instance, before the engine is
started up for the first time in the day).
– Unscrew cap 1;
– top up the level (as a guide, the ca-
pacity between the “mini" and the
"maxi" reading on the dipstick 2
is between 0.33 and 0.44 gallons
(1.5 and 2 litres) depending on the
engine);
– wait for approximately 20 minutes to
allow the oil to flow into the engine;
– check the level using the dipstick 2
(as described above).
Once the operation has been com-
pleted, ensure that the dipstick is
pushed in as far as it will go or that
the “cap-type dipstick” is completely
screwed in.
Do not exceed the “maxi" level and
do not forget to refit the cap 1 and
the dipstick 2.
1
1
2
Before carrying out any
action in the engine com-
partment, you must switch
off the ignition. ➥ 2.4
➥ 2.5.
2
1
2
Adding engine oil
Use a funnel or protect the
filling neck area to avoid
engine oil escaping onto a
hot part of the engine compartment
or a sensitive part (e.g. electrical
components).
Fire hazard.
To Next Page
Loading...
