clock
setting ..................................................
(current page)
fuel consumption .......................................
(current page)
tyre pressure..............................................
(current page)
mileage before service ..............................
(current page)
maintenance:
mileage before service .........................
(current page)
additional tank capacity .............................
(current page)
1.84
ENG_UD60345_1
Ordinateur de bord : généralités (BFB - KFB - Renault)
trip computer
TRIP COMPUTER: general information (4/4)
Selections
(the display depends on the vehicle
equipment and country)
a) Trip log, operating faults and infor-
mation message readout;
b) current fuel consumption and aver-
age fuel consumption;
c) trip mileage recorder and average
speed;
d) Reset the tyre pressure;
e) set the time;
f) distance before service;
– Distance before service;
– Mileage before oil change.
g) Estimated range with remaining rea-
gent.
Resetting the trip mileage
recorder and journey
parameters (reset button)
With one of the trip parameters se-
lected as the display, press and hold
the 4 switch “OK” until the display
resets to zero.
Automatic resetting of the
journey parameters
Resetting occurs automatically when
the maximum value of any of the pa-
rameters is exceeded.
Interpreting some of the
values displayed after
resetting
The values showing average fuel con-
sumption, range and average speed
will become more stable and reliable
the further you travel after pressing the
reset button.
For the first few miles after pressing the
reset key you will notice that the range
increases as you travel. This range
takes into account the average fuel con-
sumption since the last time the reset
button was pressed. However, average
consumption can decrease when:
– the vehicle stops accelerating;
– the engine reaches its operating
temperature (if the engine was cold
when the reset key was pressed);
– when driving from an urban area
onto the open road.
3
4
4
To Next Page
Loading...
