7
6
1
6
5
3
NU710_6_G3-FRA 4/03/05 9:54 Page 3.21
J77 - NU710-5
C:\Documentum\Checkout\NU710_6_T3-ENG.win 2/5/2005 9:39
-page21
3.21
ELECTRIC PANORAMIC SUNROOF (continued)
To refit
Before positioning the glass, clip the
cover 6 towards the top of the
handle 1.
From outside the vehicle, position
glass runners 7 in the corresponding
hinges, then tilt the glass panel
slowly towards the rear of the
vehicle.
When the glass panel is fitted, from
inside the vehicle, position
handle 1 so that shaft 5 clips into
notch 6.
Pull handle 1 to close the sunroof.
Check that the shaft is secured
correctly in the handle by pushing
the glass panel upwards.
- Ensure the sunroof is properly
closed before leaving your
vehicle.
- Clean the seal every three
months using products
recommended by our technical
services.
To Next Page
Loading...
