1
2
3
NU710_6_G1-FRA 4/03/05 9:34 Page 1.58
J77 - NU710-5
C:\Documentum\Checkout\NU710_6_T1-ENG.win 2/5/2005 9:37
-page64
1.58
TRIP COMPUTER AND WARNING SYSTEM
Trip computer and warning
system
This displays the following
information on instrument panel
display 1 (position varies according
to vehicle):
- information messages (journey
parameters etc.);
- the operating fault messages
(generally linked to the
warning light);
- warning messages (linked to the
warning light).
Display selection keys 2 and 3
Scroll through the following
information in this order or reverse
order by briefly pressing the key
repeatedly.
a) Total mileage recorder, trip
mileage recorder,
b) journey parameters:
- fuel used,
- average fuel consumption,
- current fuel consumption
(depending on vehicle),
- estimated range,
- distance travelled.
c) mileage before service,
d) programmed speed (speed
limiter/cruise control),
e) on-board log: a record of
information messages and
operating fault messages stored
by the computer.
Instrument panel in miles
It is possible to switch to km/h.
With the ignition switched off, press
either button 2 or 3 and turn the key
to the accessories position.
The speed measurement unit
indicator flashes for approximately
three seconds, then the new unit of
measurement flashes on the display
and then is displayed permanently.
Release button 2 or 3.
To return to the previous mode,
carry out the same operation.
Note: once the battery is switched
off, the trip computer automatically
returns to the original unit of
measurement.
To Next Page
Loading...
