2
1
A
1
2
NU710_6_G3-FRA 4/03/05 9:56 Page 3.34
J77 - NU710-5
C:\Documentum\Checkout\NU710_6_T3-ENG.win 2/5/2005 9:39
-page34
3.34
TRIPTIC REAR SEAT: FUNCTIONAL FEATURES
The rear seat may be configured in
two or three seat positions.
Before moving it, ensure that
nobody is occupying the seat or
preventing it from being moved.
For safety reasons, carry
out these adjustments
when the vehicle is
stationary.
For safety reasons, it is not
permitted to sit on the centre seat
position when section 1 is
raised.
Changing to the two-seat bench seat
configuration (recentring the bench
seat)
- lift centre section 1 of the seat,
- lift handle 2,
- push the seat base towards the
centre until it locks in place (the
second section of the seat is
recentred at the same time).
Make sure that the seat base locks
into position correctly.
You can then move the bench seat
forwards or backwards (four
possible positions).
Location A is not a storage
compartment.
Changing to the three-seat
configuration
- move the seat fully forwards,
- lift handle 2 and pull the seat base
until the seat locks in place
(ensure that the seat base is locked
correctly in position),
- lower centre section 1 of the seat.
You can then move the bench seat
backwards a notch (two possible
positions).
To Next Page
Loading...
