1
A
3
NU710_6_G3-FRA 4/03/05 9:55 Page 3.33
J77 - NU710-5
C:\Documentum\Checkout\NU710_6_T3-ENG.win 2/5/2005 9:39
-page33
3.33
REAR BENCH SEAT: functional features (continued)
• When returning the seatback to
its normal position, make sure
that it is properly locked at the
top. Where seat covers are fitted,
make sure these do not prevent
the seatback latch from locking.
• When moving the rear bench
seat, ensure that the seat belt
units are correctly fitted before
folding up the seatbase. When
the bench seat has been put back
in place, make sure that the seat
belts are correctly repositioned.
To replace the seatbase, proceed in
the reverse order to removal.
Lift up the rear bench seat cushion
in such a way so as to position the
rear section of the seatbase 1 under
the seatback.
Then press the front section 3 of the
cushion A in order to lock the
seatbase.
To replace the seatback, proceed in
the reverse order to removal.
Refit the seatback and click it back
into place.
To Next Page
Loading...
