2
3
A
1
4
5
6
C
D
B
NU710_6_G5-FRA 9/03/05 17:18 Page 5.06
J77 - NU710-5
C:\Documentum\Checkout\NU710_6_T5-ENG.win 6/4/2005 11:23
-page6
5.06
HUBCAPS / WHEELS
Wheel trim (example: wheel
trim 1)
Remove the wheel trim using
hubcap spanner 3 (from the tool kit)
by inserting the hook in the recess
near the valve 2.
When refitting the wheel trim, align
it with valve 3. Push the retaining
hooks in, starting with valve side A,
followed by B and C, finishing at the
side opposite the valve D.
Central wheel hubcap
(example: hubcap 4)
Remove the hubcap using hubcap
spanner 6 (from the tool kit) by
inserting spanner 6 into recess 5.
To refit, align it with recess 5 and
tighten it using spanner 6.
We would advise you to note
down the number engraved on
the key so that you can replace it
if it is lost.
To Next Page
Loading...
