1
2
4
NU710_6_G1-FRA 4/03/05 9:35 Page 1.78
J77 - NU710-5
C:\Documentum\Checkout\NU710_6_T1-ENG.win 2/5/2005 9:37
-page84
1.78
EXTERIOR LIGHTING AND SIGNALS (continued)
Switching on the dipped
beam headlights
Manual operation
Tur n t he end o f s tal k 1 until the
symbol is opposite mark 2.
In all cases, an indicator light on the
instrument panel comes on.
Automatic operation (depending
on vehicle)
With the engine running, the
dipped beam headlights switch
themselves on or off automatically
depending on ambient light,
without the need to operate stalk 1
(position 0).
This function can be deactivated or
reactivated.
- To activate it with the ignition on,
press button 4 for at least four
seconds. An instrument panel
message confirms this action.
- To deactivate it with the ignition
on, press button 4 for at least four
seconds. The “Auto lights OFF”
message is displayed on the
instrument panel.
If stalk 1 is operated, it overrides
and cancels the automatic function
temporarily.
See-me-home lighting function
This function (useful, for example,
for opening a gate, a garage, etc.),
enables you to momentarily switch
on dipped beam headlights.
With the ignition switched off and
the headlights off, pull stalk 1
towards you: the dipped beam
headlights come on for
approximately thirty seconds.
This action may be carried out no
more than four times for a
maximum lighting period of two
minutes.
To switch off the lights before they
go out automatically, turn the end of
stalk 1,thenreturnittoposition0.
To Next Page
Loading...
