Renesas RH850/F1Kx Series - Page 110

2.4
• Changed capacitor value
• Modified contents of the table and notes
•
Modified the power source of Flash
3
Added information of gain setting in the caution
4.3.5
Modified the contents of the table
4.5
Added detailed information about injected current
6.1
Modified the number of clocks on the figure of ADC conversion
time
6.3
Removed RIN and CIN values for ADC equivalent circuit, and
added reference information
6.4
• Modified note
• Modified contents of external components
•
Added guidance for formula of charge-sharing
6.5
Added information regarding sampling error
8
• Merged connection information of each device to one
section
• Removed “Debug and Flash Programming Interface
Connection when the internal HSOSC is used as Clock
Supply”
• Modified FLMD0 resistance value
•
Modified LPDIO resistance value
9
Modified FLMD0 resistance value
10
Deleted contents and referred F1KM Migration Guide
1.10
2019-08-08
-
• Typing error correction
• Description of RH850/F1K series added to related chapters
• Document references updated to cover RH850/F1Kx and
RH850/F1K documentation
1.4.4
Modified Figure 14 and Figure 15
2.1
Capacitor and resistor re-numbered
3.1.1
Updated MOSC table to include RH850/F1Kx and RH850/F1K
3.2
Reference of “PCB-Design for Improved EMC” removed
4.1.1
Adjusted description to be synchronized with RH850/F1Kx and
RH850/F1K HW UM
4.2.1
Reference of “PCB-Design for Improved EMC” removed
5
• Chapter title updated
•
Reference of application note removed
8.1
• Note added at P10_8 (FLMD1) for clarification and
understanding
• Removed pull-up resistance on JP0_0/TDI/LPDIO/LPDI at
LPD4 as it is only required for LPD1
• Caution about P10_8/FLMD1 removed
• Target connector name on Figure 40 modified
8.2
PG-FP5 replaced by PG-FPx
8.2.1
• Note added at P10_8 (FLMD1) for clarification and
understanding
• Caution about P10_8/FLMD1 removed
• PG-FP5 replaced by PG-FPx
8.2.2
• Note added at P10_8 (FLMD1) for clarification and
understanding
•
PG-FP5 replaced by PG-FPx
8.3
• Target connector name on Figure 43 modified
11
• Reference of SENT application note removed
• Reference of “PCB-Design for Improved EMC” removed
• RH850/F1K hardware manual added
• E1/E2 emulator add-on manual for F1K added
•
PG-FP6 flash programmer manual added