Renesas RH850/F1Kx Series - Flash Programming by E1;E2 Emulator and RFP; Figure 42: E1;E2 Flash Programming Interface Connection; Table 72: PG-Fpx Flash Programming Signal Connection

RH850/F1Kx, RH850/F1K Series Hardware Design Guide
R01AN3841ED0110 Rev. 1.10 Page 99 of 108
August 8, 2019
Note:
Design the circuit in the way that the FLMD1 pin must be at the low level during serial
programming. During programming, it outputs a low level on FPMD1 to place the device in the
serial programming mode.
If necessary, connect FPMD1 and FLMD1.
The flash programming signal connection of the PG-FPx interface is given in the table below:
Table 72: PG-FPx Flash programming signal connection
PG-FPx Interface Connector
PG-FPx Signal
Device Pin
1
SCK
JP0_2
2
GND
EVSS
3
-
-
4
FPMD0
FLMD0
5
SI/RxD
JP0_1
6
FPMD1
FLMD1
7
SO/TxD
JP0_0
8
VDD
EVCC
9
-
-
10
-
-
11
-
-
12
GND
EVSS
13 RESET RESET
14
-
-
8.2.2 Flash Programming by E1/E2 Emulator and RFP
Figure 42: E1/E2 flash programming interface connection
TVDD
GND
GND
GND
VDDVDD
EVCC
EVSS
FPDR
FPDT
FPM D0
FPM D1
RESET RESET
P10_8 (FLM D1)
No te
FLM D0
JP0_0 (RxD/TxD)
JP0_1 (TxD)
RH850/F1Kx, RH850/F1K
E1/E2 & RFP Flash
Programmer
(14pin Connector)
Min.
86kΩ
1k t o 10kΩ
JP0_4
10k to 100kΩ