Renfert BASIC eco - 1 Introduction; Employed Symbols; 2 Safety; Intended Use

EN
1. Introduction
1.1 Employed symbols
Intheseinstructionsorontheunititselfyouwillndsymbolswhichhavethefollowingmeaning:
Danger
This indicates an imminent risk of injury. Please observe the accompanying documents!
Electrical hazard
There is a risk of electrical shock.
Attention
Failure to observe the associated information can result in damage to the unit.
Note
The operating instructions contain useful information to make handling easier.
Attention!
Wear eye protection.
The unit complies with the relevant EC guidelines.
The unit is subject to the EC guidelines 2002/96/EG (WEEE Directive).
► List, particular attention should be paid
• List
- List according to importance.
⇒ Instructions / appropriate action / input / operational sequence:
Youwillbeaskedtocarryouttheactioninaspeciedorder.
♦ Result of an action / reaction of the device / reaction of the program:
Theunitorprogramreactsasaresultofyouractionsorwhenaspecicincidentoccurs.
Other symbols are explained as they occur.
2. Safety
2.1 Intended use
The Basic line of sandblasting units are designed for use in dental laboratories to remove investment
residues, oxides on cast objects, and for surface treatment.
Other areas of use also include divesting press ceramic or sandblasting porcelain occlusal surfaces.
2.2 Improper use
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
device, increase the risk of serious injury and lead to damage to the environment or the device itself.
- 3 -