Renkforce RF-IR-200 - Operation

41
b) Connecting headphones
You can connect headphones to the jack (13) if required.
• Connect the headphones plug to the
jack (13).
• Iftheheadphonesplugdoesnottintothejack,useanadapter.
When the headphones are connected to the jack (13), the built-in loudspeaker turns off. In this case,
only the headphones play sound.
10. Operation
a) Switching on for the rst time
Keep the button (2) on the device pressed until the display (7) goes on.
The start-up process takes a few seconds.
b) Language settings
 Whenthedeviceisswitchedonforthersttime,orifyouhadpreviouslyresetittofactorydefaultsettings,
the language selection appears on the display (7) after switching on.
Usetherotaryknob(11)toselectthedesiredlanguageandpressittoconrm.