Renkforce RF1000 - 13 Operation At The Printer; A) Menu Overview

65
13. Operation at the Printer
a) Menu Overview
Operation takes place via the left key block at the printer:
• The direction buttons are used for navigation in the menu structure (left / right / top / bottom)
• The OK button is used to confirm a selection in the menu and to call the menu structure from the main menu (description above
under “Mains Connection and First Activation“).
The menu structure may deviate slightly depending on firmware.
Quick Settings Home All
Speed Mul.:100%
Flow Mul.:100%
Preheat PLA
Preheat ABS
Cooldown
Disable Stepper
Output Object
Restart
Bed Temp.: 0°C
Print file
Position Home All
Home X
Home Y
Home Z
X Position X: 0.00 mm
Min endstop: O
Max endstop: N/A
Y Position Y: 0.00 mm
Min endstop: O
Max endstop: N/A
Z Position Z: 0.00 mm
Min endstop: O
Max endstop: N/A
Extr. position E: 0.00 mm
1 click = 1 mm
Extruder Bed Temp.: 0°C
Temp. 0 : 0°C
Extruder 0 O
Extruder position E: 0.00 mm
1 click = 1 mm
Set Origin
Fan speed Fan Speed: 100%
Turn Fan O
Set Fan 25%
Set Fan 50%
Set Fan 75%
Set Fan Full