Renkforce WH2315 - Page 78

78
• Use the " " (3) or " "(4)buttonstoselectthealarmyouwanttoset.Therespectivelyselectedvalueashes.
If the area with the time (upper left in the display) is selected, the lower text lines show "TIME ALARM" and
you can set the alarm time.
• Changetheashingvaluewiththe"
" (1) or " " (2) button. Keep the respective button pressed for quick
adjustment.
• To switch the alarm (or the alarm time) on or off, push the "SET" (5) button with the currently selected alarm.
When the alarm is activated, a bell icon " " is displayed at the lower right.
 Toleavethesettingmodeinanyplace,brieypushthebutton"HISTORY"(7).Thesettingsmadeare
saved.
Alternatively, wait for 30 seconds without pushing a button. Setting mode is ended automatically in this
case.
• When an alarm is triggered (exceeding of a threshold at "HIGH ALARM", undercutting of a threshold at "LOW
ALARM" or at the alarm time), the basis station will emit a sound signal and the bell icon "
"ashes.Thecor-
responding text message appears at the bottom of the display.
• Push any button to end the sound signal. If the measured value remains above or below the set threshold, the bell
icon "
"willcontinuetoash,however.