To Next Page
M
Mitchell HawkinsAug 14, 2025
Why is the weather forecast not right on my Renkforce Weather Station?
- EElizabeth DixonAug 15, 2025
The weather forecast accuracy is about 70% because it's calculated based on barometric pressure observations.
Why is the weather forecast not right on my Renkforce Weather Station?
The weather forecast accuracy is about 70% because it's calculated based on barometric pressure observations.
What to do if the wind direction is wrong on Renkforce Weather Station?
Ensure that the wind direction sensor is aligned to the north, referencing the "N" label on the sensor. Also, consider that a storm might have shifted the outdoor sensor's position.
What to do if the rain sensor shows wrong data on Renkforce Weather Station?
Inspect the rain sensor's funnel for any obstructions like leaves or debris, and remove them.
How to fix Renkforce 2203406 Weather Station when the basis station won't adjust to the DCF data or can't find the outdoor sensor?
If the basis station doesn't adjust to the DCF data or can't find the outdoor sensor, consider these steps: * Remove batteries from the basis station and outdoor sensor, cover the solar module, wait a few seconds, then reinsert the batteries into the basis station first. When the basis station shows the indoor temperature/humidity, insert the rechargeable batteries in the outdoor sensor (remove the cover from the solar module again). The LED must light up for 6 seconds. If not, charge the batteries in full sunlight for a day. * Wait for 10 minutes without pushing any buttons. * If reception is poor, manually set the time and date after switching off DCF reception. * Start registration via "REREGISTER TRANSMITTER" and briefly push the "RESET" button on the solar module's bottom.
What to do if measured values deviate from other devices on Renkforce Weather Station?
You can set an offset to be added to or subtracted from the displayed values using the "CALIBRATION SETTING".
What to do if Renkforce Weather Station base station won't adjust to DCF data or find the outdoor sensor?
If your Renkforce Weather Station base station isn't syncing with DCF data or finding the outdoor sensor, try these steps: First, remove the batteries from both the base station and the outdoor sensor, and cover the solar module. Wait a few seconds, then reinsert the batteries into the base station. Once the base station displays indoor temperature and humidity, it will begin scanning for the outdoor sensor. Next, insert the batteries into the outdoor sensor, removing the cover from the solar module. The LED should light up for 6 seconds. If it doesn't, charge the batteries in full sunlight for a day. Wait 10 minutes, and avoid pressing any buttons on the base station to prevent interrupting the sensor scan.
Why is the wind direction wrong on my Renkforce 2203406 Weather Station?
To correct a wrong wind direction in your Renkforce Weather Station, check that the wind direction sensor is aligned to the north, using the label “N” on the sensor as a guide. It's also possible that a storm has shifted the entire outdoor sensor.
What to do if Renkforce 2203406 Weather Station rain sensor shows wrong data?
If your Renkforce Weather Station's rain sensor is showing incorrect data, inspect the funnel for any obstructions like leaves or debris, and remove them.
How to calibrate measured values on Renkforce 2203406?
If the measured values from your Renkforce Weather Station deviate from other devices, you can adjust the displayed values by setting an offset to be added to or subtracted from them. Refer to chapter 11. c) for "CALIBRATION SETTING".
General| Brand | Renkforce |
|---|---|
| Model | 2203406 |
| Type | Weather Station |
| Display Type | LCD |
| Functions | Temperature, Humidity, Weather Forecast |
| Radio frequency | 433 MHz |
| Wireless Transmission Range | 100 meters |
| Power Supply | Battery |
| Batteries included | Yes |