Renkforce 2203406 - D) Alarm Mode

67
d) Alarm mode
The alarm time can be set in this mode as well.
• Thebasestationmustbeinnormalmode.Nowbrieypushthe"ALARM"(6) button to start the alarm mode.
• The two lower text lines show "HIGH ALARM".
 Toleavethealarmmodeinanyplace,brieypushthebutton"HISTORY"(7). The settings made are saved.
Alternatively, wait for 30 seconds without pushing a button. Alarm mode is ended automatically in this case.
• Pushing the "ALARM" (6) button again switches between "LOW ALARM" and "HIGH ALARM".
The following settings are available at "HIGH ALARM":
"TIME ALARM" Alarm time
"LIGHT HIGH ALARM" Lighting strength
"UVI HIGH ALARM" UV-index
"IN TEMP HIGH ALARM" Indoor temperature
"IN HUMI HIGH ALARM" Indoor humidity
"OUT TEMP HIGH ALARM" Outdoor temperature
"OUT HUMI HIGH ALARM" Outdoor humidity
"ABS BARO HIGH ALARM" Absolute barometric pressure
"REL BARO HIGH ALARM" Relative barometric pressure
"WIND HIGH ALARM" Wind speed
"GUST HIGH ALARM" Wind gust speed
"DEW POINT HIGH ALARM" Dew point
"HEAT INDEX HIGH ALARM" Heat index
"RAIN RATE HIGH ALARM" Rain volume
"RAIN DAY HIGH ALARM" Daily rain volume
The following settings are available in "LOW ALARM":
"IN TEMP LOW ALARM" Indoor temperature
"IN HUMI LOW ALARM" Indoor humidity
"OUT TEMP LOW ALARM" Outdoor temperature
"OUT HUMI LOW ALARM" Outdoor humidity
"ABS BARO LOW ALARM" Absolute barometric pressure
"REL BARO LOW ALARM" Relative barometric pressure
"WIND CHILL LOW ALARM" Wind-chill temperature
"DEW POINT LOW ALARM" Dew point
• Use the " " (3) or " " (4)buttonstoselectthealarmyouwanttoset.Therespectivelyselectedvalueashes.
If the area with the time (upper left in the display) is selected, the lower text lines show "TIME ALARM" and
you can set the alarm time.
• Changethe ashingvalue withthe" " (1) or " " (2) button. Keep the respective button pressed for quick
adjustment.