66
Setting function "CALIBRATION SETTING"
The base station is pre-calibrated for all available displays. There may still be deviations as compared to the measur-
ing data of professional measuring technology.
If you have a professional thermometer, for example, the temperature display on the base station can be adjusted to
the measured value of your thermometer with an offset value.
The offset value set is added to (or subtracted from) the value measured by the base station or outdoor sensor before
it is displayed. A factor can be set in some displays. The value measured by the base station or outdoor sensor is
multiplied with a factor here before it is displayed.
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the " " (3)brieyrepeatedlyuntilthesettingfunction"CALIBRATIONSETTING"isdisplayed.
Push the " " (4) button several times to select the measuring function that you want to calibrate.
Use the " " (1) or " " (2) buttons to set the calibration value now.
The following measuring function can be calibrated:
"LIGHT FACTOR" Factor for lighting strength
"ULTRAVIOLET FACTOR" Factor for UV-index
"IN TEMP OFFSET" Offset for indoor temperature
"IN HUMI OFFSET" Offset for indoor humidity
"OUT TEMP OFFSET" Offset for outdoor temperature
"OUT HUMI OFFSET" Offset for outdoor humidity
"ABS BARO OFFSET" Offset for absolute barometric pressure
"REL BARO OFFSET" Offset for relative barometric pressure
"WIND DIR OFFSET" Offset for wind direction
"WIND SPEED FACTOR" Factor for wind speed
"RAINFALL FACTOR" Factor for rain volume
"RAIN DAY CALIBRATION" Correction of the rain volume of the current day
"RAIN WEEK CALIBRATION" Correction of the rain volume of the last week
"RAIN MONTH CALIBRATION" Correction of the rain volume of the last month
"RAIN YEAR CALIBRATION" Correction of the rain volume of the last year
"RAIN TOTAL CALIBRATION" Correction of the rain volume of the total rain volume
Setting function "TRANSMITTER ID"
No settings are possible here. The base station displays the radio ID of the outdoor sensor.
To Next Page
Loading...