RepRap Prusa i3 - INTRODUCTION; Target; Authors and Credits; Sources and Links

2
Document Version 1.1.16
INTRODUCTION
• Target :
Prupose a visual guide of the dierents steps to build and use a
Prusa i3 Rework.
• Authors of this document :
eMotion Tech – http://www.Reprap-France.com
Hugo FLYE
Quentin CESVET
Anthony BERNA
• Photographics Credits :
Pictures and 3D représentations made by eMotion Tech
http://www.emotion-tech.com
• Sources :
http://reprap.org/wiki/RepRap
http://www.repetier.com/
• Licences :
Prusa i3 : GPL 3.0
is document : CC BY-NC-SA 4.0
http://creativecommons.org/licenses/by-nc-sa/4.0/
• Update :
Last update : 22/11/2016
• Links :
You can found more informations on the following links :
RepRap community : http://reprap.org/wiki/reprap
Repetier-Host soware : http://www.repetier.com/
3D models database : http://www.thingiverse.com/
RepRap