Need help?Do you have a question about the RepRap X500 and is the answer not in the manual?
General| Build Volume | 500 x 500 x 500 mm |
|---|---|
| Print Speed | Up to 150 mm/s |
| Filament Diameter | 1.75 mm |
| Heated Bed | Yes |
| Bed Temperature | Up to 120°C |
| Nozzle Temperature | Up to 300°C |
| Supported Materials | PLA, ABS, PETG, TPU, Nylon |
| Connectivity | USB, SD card |
| Nozzle Diameter | 0.4 mm (interchangeable) |
| Software | Cura, Simplify3D, Repetier-Host |
| Power Supply | 24V |
Lists technical specifications such as working space, printing speed, temperature limits, and dimensions.
Explains how to start the printer, its functions in operating mode, and warnings about opening the lid.
Details the maintenance mode intended for repair work, requiring trained professionals.
Explains how to connect the X500 to a network, mentioning DHCP and IP address assignment.
Details the initial setup routine steps, including language selection and requirement checks.
Guides on activating the printer and establishing a connection via the Repetier-Server dashboard.
Explains how to access the Repetier Server web interface using the printer's IP address.
Explains how to access and modify EEPROM settings, with a warning about potential damage.
Details the process of updating the printer's firmware using Repetier-Server.
To Next Page
