Installation site
Like every electronic device this printer generates heat. Even though the heat radiation meets the statutory
requirements, sensible surfaces might be discolored over the time. Therefore, we recommend to install the
printer on an even and sturdy surface. You should also care for a good reachability and an adequate working
height.
Disposal
Electronic equipment may not be disposed in domestic waste. In accordance with directive 2002/96/EG of
the European Parliament and the Council of 27th January 2003 about electric and electronic equipment it
must be professionally disposed. At the end of its use please dispose this device at a public colleting point
intended for this.
12. Legal disclaimers
Software modications/ use of applications
Modications to the printer´s software or the use of unauthorized applications not supplied by German
RepRap GmbH will void the device´s warranty. Shipping costs as well as the repair cost caused by using
unsupported software are billed to the customer.
Only use the software packages provided by German RepRap GmbH via download at their website at http://
www.germanreprap.com.
German RepRap GmbH cannot be held liable for the loss of data on any external or internal storages. The
device has been preinstalled with software and works as can be reasonably expected. It cannot be guaran-
teed that the software is error free. If it is possible to use the printer as designed an error in the software
does not constitute a faulty device and hence provides no grounds to a warranty claim. The warranty only
covers faults that would prevent the normal usage of the printer.
Limitations of the software caused by hardware faults, the environment the printer is being used in, opera-
ting errors or similar reasons are not considered software faults.
Contact
German RepRap GmbH
Kapellenstr. 9
85622 Feldkirchen bei München
Deutschland
Tel: +49 89 2488986 0
Fax: +49 89 2488986 99
Mail: info@germanreprap.com
Hilfe: support@germanreprap.com
Web: http://www.germanreprap.com
42/45
To Next Page
Loading...
