6.5 FS Workaround
The following workaround will be implemented in furhter releases and needs to be manual adjusted for
the rst series of machines.
In order to let the printer cool down after it reached the parking position add the following lines in the
G-Code tab in the Repetier Server.
The red marked area causes the printer to pause and then cool down. This prevents
hotends from cooling down during emptying buffer.
workaround fs triggered, x500
After all pre-stored commands have been executed the printhead moves to a parking position and the
extruder pushes out the rest of the lament.
Open the door of the material storage and rst take out the leftover lament. After inserting a new spool
of lament the hotend gets heated up again and you can feed it through the tube, to the toolhead, by
hand. Use the front display to extruder a few centimeters of lament.
Finally press „Proceed Print“ on the display and the X500 continues the printjob.
G1 X0
G1 Y800
G1 X500
G4 S1
M601 S1
35/45
To Next Page
Loading...
