/ 27
ANNEX
Functionalities for the placement
We will rst choose a 3D model to print. We suggest you to start with a simple object like the «Y Motor», with a fairly large plate surface to
be able to observe the printing of the rst layer (decisive) as comfortable as possible.
IYou can also go to the ingiverse website and nd a simple object to print (cube or another simple objet without diculty).
Also be sure to apply a grip coating (polyimide or blue tape) on the plate to optimize adhesion of the material, this is an important detail
for a successful print.
Printing of a piece with Repetier Host
To Next Page
Loading...
