/ 3
INTRODUCTION 2
Summary 3
Driver and the rmware installation 4
Transfer of the rmware from Arduino 7
Connection to Repetier-Host 8
Conguration and preset 11
Checking endstop 13
Invert motor’s direction 15
Fan checking 15
HEATED PARTS CHECKING 16
Extruder 16
USING Z SENSOR 18
Checking the sensor 19
Balancing Z motors 20
Z-Axis calibration 21
Auto-Leveling 23
SUMMARY
ANNEX 24
Adaptation of the Start G-code 25
Printing of a piece with Repetier Host 27
GCODE commands 37
Maintenance 38
Recommandations 38
To Next Page
Loading...
